If there is no power source available then use an external charger for at least an hour. The battery can be recharged by plugging it in to a 12v car socket or solar panel for 2-5 hours. If your type S jump starter has a blinking red light, this means that the battery inside the unit is low. A list of Type S jump starter common problems Be sure to read and follow all safety and handling instructions on the battery and this website. If your car does not start by jump-starting, you may have a problem with your starter, alternator or another component of the electrical system. If the car starts right away, your problem is most likely a dead battery.Ĭharge the battery and clean the terminals and cable connectors to ensure good contact. If you can’t test the battery, try jump-starting. If you have a battery tester that can measure cranking amps, use it to see if the battery is weak. Why Your Car Isn’t Starting?Įveryone wonder why your car won’t start? One of the reasons may be a weak or dead battery. Make sure that you have installed all of your apps before beginning to use your type s jump starter. This may help to reset your device’s settings. You can also remove the batteries from both ends of the power cord and put them back in. If this does not work, then try disconnecting the battery from the power cord and then reconnect it again. If it is not, then try to plug it in again and make sure that your device turns on. Please reference user manual for full instructions and warnings. Make sure the power cord is securely plugged into an outlet. Once the vehicle starts, remove the jumper cable from the unit. ![]() Plug the blue cord jumper cable into the jump start socket, and ensure the blue plug is secured.ħ. Ensure the battery clamps are connected correctly, and the connectors are free from rust and dirt.ĥ. ![]() Caution! Do not connect the red clamp (+) and the black clamp (-) at the same time.Ĥ. The black battery clamp of jumper cable to the vehicle’s negative (-) battery terminal.ģ. Connect the red battery clamp of jumper cable to the vehicle’s positive (+) battery terminal and connect Check that the number of indicator lights is not less than 3.Ģ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |